Tektronix Phaser 600 Changing the printers language mode

CHANGING THE PRINTER’S LANGUAGE MODE

522

Changing the printer’s language mode

The Phaser 600 printer supports the following printer languages:

■PostScript Level 1 and Level 2

■HP-GL (Hewlett-Packard Graphics Language)

In the factory default conﬁguration, the printer expects to receive PostScript data on

all ports. If you want to use an HP-GL application, you must explicitly set up a

printer port to receive HP-GL data, or enable Adobe IntelliSelect™ automatic

language selection.

Changing the language of the printer between PostScript and HP-GL is

port-speciﬁc. The ports, such as parallel, serial, or LocalTalk, can each be

conﬁgured differently. You can change the default language on any port so

whenever the printer is turned on it expects to receive PostScript or HP-GL data on

a speciﬁc port. If automatic language selection is enabled on a particular port, it

becomes the default on that port, allowing you to send PostScript and HP-GL ﬁles to

that port.

Changes to the language on any port remain in effect even if the printer is turned off

or reset.