Tektronix Phaser 600

SETTING POSTSCRIPT AND HP-GL JOB AND WAIT TIMEOUTS

518

You can use the

CONFIG.PS

ﬁle to change the PostScript and HP-GL job and wait

timeout values. When sent to the printer, your edited version of the

CONFIG.PS

ﬁle

changes the values in the printer, but

only

while the printer is turned on; if the printer

is turned off or reset the values return to their defaults. To restore your desired

timeout settings, you must send your edited

CONFIG.PS

ﬁle to the printer again.

NOTE

The CONFIG.PS ﬁle affects printer operation. If the printer is shared on a network,

using this ﬁle may affect the prints requested by other users.

1Conﬁgure the printer’s port to receive PostScript; see Printing PostScript ﬁles

for instructions.

2Locate the utility ﬁles on the Phaser 600 printer’s CD-ROM; refer to Installing

the ﬁles for instructions.

3Copy the

CONFIG.PS

ﬁle to your hard disk, and open the ﬁle in a text editor.