Toshiba T2150CD user manual PS/2 Mouse, Serial Mouse

Problem	Procedure
On-screen pointer does not respond to	If a PS/2 or serial mouse is connected, check the
AccuPoint operation	Setup program. The Pointing Device option in the
	Others option box should be set to Simultaneous
	to use both the AccuPoint and an external mouse.
	Make sure the following lines are contained in your
	AUTOEXEC.BAT file:
	PATH %PATH%;C;\MOUSE
	SET LMOUSE=C:\MOUSE
	C:\MOUSE\MOUSE
	SET TEMP=C:\DOS
	These lines are necessary to load the AccuPoint
	driver. If they are not there, add them to your
	AUTOEXEC.BAT file.
	Reload the AccuPoint driver from your backup
	diskettes, if you made them as advised earlier in the
	manual.
	If problems persist, contact your dealer.
PS/2 Mouse
Problem	Procedure
On-screen pointer does not respond to	Check that the PS/2 mouse cable’s 6-pin connector is
PS/2 mouse operation	firmly connected to the mouse port on the port
	replicator and that the replicator is firmly connected to
	the computer.
	You may have connected the mouse after turning the
	computer on. Turn off the computer, make sure the
	mouse is firmly connected and turn the computer back
	on.
	Confirm that your CONFIG.SYS or
	AUTOEXEC.BAT contains a mouse driver.
	Is your software configured to recognize the mouse?
	Check the software documentation.
	If problems persist, contact your dealer.
Serial Mouse
Problem	Procedure