Yamaha AW4416 manual Make monitor settings, Press the PAN key → F3 key

Chapter5—Recording on the AW4416

Make monitor settings

We will make settings so that the signal of the rhythm machine (drums) that were earlier recorded on tracks 1/2 and the bass signal being recorded on track 3 will be sent to the stereo bus, and can be monitored via the MONITOR OUT jacks or PHONES jack.

1.Press the [PAN] key → [F3] key.

The PAN/ROUTE screen PAN Moni page will appear, allowing you to make pan and bus assignment settings for monitor channels 1–16.

2.For monitor channel 3, turn the ST button on and the bus assign 1–8 buttons off.

At this time, verify that the ST button is on and the bus assign 1–8 button is off for monitor channels 1–2 as well.

3.Move the cursor to the PAN knob of monitor channel 3, and pan the bass where you can monitor it most comfortably.

4.Make sure that [ON] key 3 is turned on. Then produce sound on your bass, and raise fader 3 to a volume that is comfortable for monitoring.

90 — Operation Guide