Yamaha AW4416 manual In/out points, Setting the In point/Out point

Chapter6—Transport/locate operations

In/out points

The AW4416 remembers the locations at which recording was last begun and ended as the In point and the Out point. When the In and Out points are memo- rized, the [IN] and [OUT] keys will light. In this state, you can press the [IN] key or the [OUT] key to locate to the In or Out points. You can also set the In or Out points manually.

❒Setting the In point/Out point

1.Locate the song to the location where you wish to set the In point.

2.Hold down the Locate section [SET] key and press the [IN] key.

	MARK SEARCH
NUM	7	8	9
			MARK
LOCATE
		LAST REC
AUTO	4	5	6
	IN	OUT	SET
PUNCH
	1	2	3
REPEAT	A	B	ROLL
			BACK
	0		CANCEL
	RTZ

NO

3.Locate the song to the location where you wish to set the Out point.

4.Hold down the [SET] key and press the [OUT] key.

	MARK SEARCH
NUM	7	8	9
			MARK
LOCATE
		LAST REC
AUTO	4	5	6
	IN	OUT	SET
PUNCH
	1	2	3
REPEAT	A	B	ROLL
			BACK
	0		CANCEL
	RTZ

NO

The In point and Out point that you specify will be displayed as follows in the TRACK screen TR View page that appears when you press the [TRACK] key → [F1] key.

In point Out point

Tip!

•The In/Out points are also used as the auto punch-in/out points used by auto punch-in/out (→ P.130).

•The In/Out point settings are saved on the hard disk as part of the currently selected song.

You must set the In point ahead of the Out point.

120 — Operation Guide