Yamaha AW4416 manual RTO HOST connector, SPOWER switch, TAC INLET connector, UMTC OUT connector

Chapter2—Parts and their functions

•To connect the AW4416 to an external device, use only high-impedance SCSI cables shorter than 1 meter and with an impedance of 100 ohms (±10 ohms).

•Storage devices connected to the SCSI connector are used for data backup. They cannot be used directly for recording or playback.

•The only types of SCSI-2 storage devices that can be connected are MO, HD, and CD-R/W drives. For a list of manufacturers and models of storage device that are known to work with the AW4416, please refer to the website <http://www.aw4416.com>

RTO HOST connector

This is an 8-pin mini-DIN connector that can be connected directly to the serial port of a PC or Macintosh, allowing MIDI applications programs to be used.

SPOWER switch

This switch turns the power on/off.

TAC INLET connector

Connect the included power supply cable here to supply power to the unit.

Use only the included power supply cable.

UMTC OUT connector

These connectors are used to send and receive MIDI messages to and from exter- nal MIDI devices. The MIDI IN connector receives messages. The MIDI OUT/ THRU jack can function either as a MIDI OUT or MIDI THRU connector, depending on the setting of the MIDI screen → MIDI Setup page MIDI OUT SELECT. parameter. The MTC OUT connector is an output connector dedicated to MTC (MIDI Time Code) messages.

VMIDI OUT/THRU connector

WMIDI IN connector

XMOUSE connector

This is a D-sub 9-pin (male) connector for connecting a serial mouse. By using this connector, you can use a mouse to select parameters within the display or to change pages.

YFOOT SW jack

An optional foot switch (Yamaha FC5) can be connected to this jack, and used to play/stop the transport, or to manually punch-in/out.

If a foot switch of the wrong format is connected, the unit may not operate cor- rectly.

ZGrounding connector

To reduce the risk of electrical shock, connect this to a grounding connection (earth) before you connect the power cable. This unit comes with a three-conduc- tor power cable. In this case, the same result will be obtained if the ground pin of the electrical outlet is connected to ground. This will also reduce hum and noise.

— Operation Guide 49