Yamaha AW4416 manual Using AUX send/return to apply an effect, Patching

Chapter10—Internal effects

Using AUX send/return to apply an effect

As an example of using an effect with AUX send/return, here’s how to apply effect 1 via AUX bus 7.

❒Patching

Make sure that the AUX send/return patching for effect 1 is appropriate.

1.Press the [SETUP] key → [F1] (Patch IN) key.

The SETUP screen Patch IN page will appear.

If the Patch IN tab is not assigned to the [F1] key, press the [SHIFT] key + [F1] key to switch the tab, and then press the [F1] key.

2.Make sure that the EFFECT PATCH parameter EFF1 is set to “AUX 7.”

The EFFECT PATCH parameters select whether effects 1/2 will be used via AUX or inserted into a specific channel. By default, EFF1 (effect 1) is assigned to AUX 7 and EFF2 (effect 2) is assigned to AUX 8, as shown above.

Tip!

If EFF1 is set to “INSERT,” move the cursor to the “INSERT” field and use the [DATA/ JOG] dial to change it to “AUX 7.” Then move the cursor to the OK button and press the [ENTER] key.

3.Make sure that the MIXER CHANNEL INPUT ASSIGN parameter RTN1 is set to “EFF1 L/R.”

The MIXER CHANNEL INPUT ASSIGN area switches the signal that is assigned to the input channel/return channel of the mixer. By default, “EFF1 L/R” (L/R output of effect 1) is assigned to RTN1 (return channel 1).

Tip!

If RTN1 has been changed to another setting, move the cursor to the setting area, and rotate the [DATA/JOG] dial to change the setting to “EFF 1 L/R.”

166 — Operation Guide