Yamaha AW4416 manual Make monitor settings, Press the PAN key → F3 key, Press the MONI key

Chapter5—Recording on the AW4416

When tracks are paired, you must operate only one of the faders. Attempting to move both faders simultaneously will place a strain on the motor, and may cause malfunctions.

Make monitor settings

Now we will send the signal of monitor channels 1/2 to the stereo bus, so that it can be monitored via the MONITOR OUT jacks or the PHONES jack.

1.Press the [PAN] key → [F3] key.

The PAN/ROUTE screen Pan MONI page will appear. In this page you can make bus assignments and pan settings for monitor channels 1–16.

2.Press the [MONI] key.

Monitor channels 1–16 will be selected as the mixing layer.

3.Hold down [SEL] key 1, and press [SEL] key 2.

Just as we did for input channels 1/2, we will also pair monitor channels 1/2. When you simultaneously hold down the monitor channel 1/2 [SEL] keys, the CHANNEL PAIRING popup window will appear.

4.Move the cursor to one of the three buttons and press the [ENTER] key.

Monitor channels 1/2 will be paired.

5.In the monitor channel 1/2 area, make sure that the ST buttons are on and the 1–8 buttons are off.

With these settings, the signal of the monitor channels will be sent to the stereo bus.

— Operation Guide 83