Yamaha AW4416 DINSERT I/O 1/2 jacks, EINPUT 3–8phone jacks, FINPUT 8 HI-Zjack, HOMNI OUT 1–4jacks

Chapter2—Parts and their functions

DINSERT I/O 1/2 jacks

These are TRS phone jacks that allow an external effect etc. to be inserted into the input signal of INPUT jacks 1/2. Nominal input level is 0 dB. Pin connections are as follows.

OUT
IN	1/4" TRS phone plug

Sleeve (ground)

To the INSERT I/O jack of the AW4416

1/4" phone plug

To the input jack of the external processor

1/4" phone plug

To the output jack of the external processor

Tip (OUT)

Sleeve (ground)

Tip (IN)

Sleeve (ground)

EINPUT 3–8 (phone) jacks

These are balanced TRS phone type input jacks. The specifications are the same as for 3 INPUT 1/2 (phone) jacks.

FINPUT 8 (HI-Z) jack

This is a high impedance unbalanced phone type input jack. Instruments with a high output impedance such as passive type electric guitars can be directly con- nected here. Nominal input level is –46 dB– +4 dB.

If plugs are inserted into both the normal INPUT 8 (BAL) jack and the INPUT 8 (HI-Z) jack, the INPUT 8 (HI-Z) jack will take priority.

G2.5" HARD DISK DRIVE slot

This slot allows an IDE 2.5 inch hard disk to be installed.

Note

•For the procedure of installing the hard disk, refer to page 2.

•For a list of manufacturers and models of hard disk that are known to work when installed in the AW4416, please refer to the website <http://www.aw4416.com>

HOMNI OUT 1–4 jacks

These are unbalanced phone jacks that output the analog signal assigned to OMNI OUT 1–4 in the SETUP screen → Patch OUT page (→ P.136). Nominal output level is 0 dB.

IMONITOR OUT jacks

These are balanced TRS phone jacks that output analog monitor signals such as the stereo bus, internal metronome, solo signal, or direct output from recorder tracks 1–16. Nominal output level is +4 dB.

JSTEREO OUT jacks

These are unbalanced RCA phono jacks that output the analog signal assigned to ST OUT in the SETUP screen → Patch OUT page (→ P.136). Nominal output level is –10 dBV.

— Operation Guide 47