Yamaha AW4416 manual Digital cascade connections, Oscillator, Stereo output channel

Chapter1—Welcome to the world of the AW4416

Digital cascade connections

The input signal from the rear panel DIGITAL STEREO IN jack can be cascaded directly into the stereo bus, instead of being sent via the input patch section and patched to a pair of input channels. This is convenient when you wish to use an external digital mixer without linking it to the mixer section of the AW4416. Set- tings for cascade connection are made in the SET UP screen D.InSetup page.

* For the signal flow diagram, refer to Oscillator, below.

Oscillator

The AW4416 has a built-in oscillator section that allows you to select a sine wave (100 Hz, 1 kHz, 10 kHz) or white noise. The signal of the oscillator can be output from one of the following buses: buses 1–8, AUX buses 1–8, or the stereo bus.

Oscillator settings are made in the UTILITY screen Oscillator page.

BUS1 BUS2 BUS3 BUS4 BUS5 BUS6 BUS7 BUS8 STEREO L STEREO R SOLO L SOLO R

ENABLE ATT

DIGITAL STEREO L

DIGITAL STEREO R (BUS CASCADE)

AUX 1

...

AUX 6 AUX 7(EFF1) AUX 8(EFF2)

ON ATT

OSC

Stereo output channel

This is the stereo output channel that processes the signals sent from each chan- nel to the stereo bus. It provides the same four-band EQ and dynamics processor as do the input channels. The output signal of the stereo output channel is sent via the output patch section to the various output jacks, and is simultaneously output from the MONITOR OUT jacks and the PHONES jack.

When an internal or external CD-RW drive is used to play back an audio CD, the CD audio signal is patched to a point before the fader of the stereo output chan- nel.

— Operation Guide 27