Yamaha AW4416 manual Press PAN key → F2 key

Chapter5—Recording on the AW4416

5.Press [PAN] key → [F2] key.

The PAN/ROUTE screen Pan 17–24 page will appear, allowing you to make pan settings and bus assignments for input channels 17–24 and return channels 1/2.

6.Make sure that the RTN1 (return channel 1) area ST button is on, and that the two PAN knobs are turned to the far left and right.

With these settings, the return signal from effect 1 will be sent to the stereo bus and mixed with the signals of the monitor channels.

7.Press the [MONO] key → [AUX 7] key.

Monitor channels 1–16 will be selected as the mixing layer. In this state, faders 1– 16 will adjust the send level of the signals sent from monitor channels 1–16 to AUX 7 (effect 1).

8.Play back the song from the beginning, and use faders 1–16 to adjust the send level of each monitor channel.

9.If necessary, press the [HOME] key → [17–24 RTN] key and use fader 15 to readjust the effect return level.

Tip!

When the AW4416 is in the initial state, the faders of return channels 1/2 are set to nominal level (0 dB).

100 — Operation Guide