Yamaha AW4416 manual Using the dynamics processor

Chapter5—Recording on the AW4416

•[F] .................. Set the center frequency of each band. For each band, the range is 21 Hz–20.1 kHz.

•[G] ................. Set the amount of boost/cut for each band. For each band, the range is ±18 dB.

When you operate the EQ [Q]/[F]/[G] controls, the parameter values of that band will briefly appear in the upper right of the display.

Tip!

As an alternative way to make EQ settings, you can also use the EQ/ATT/GRP screen EQ/Att page ([EQ] key → [F1] key). The EQ/Att page displays all EQ parameters of the currently selected channel.

If the sound does not change when you operate the EQ, check whether the EQ

ON button is turned on in the EQ/ATT/GRP screen EQ/ATT page.

❒Using the dynamics processor

1.In the MIXING LAYER section, press the [1–16] key → [SEL] key 8.

[SEL] key 8 will light, and input channel 8 will be selected for control.

2.Press the [DYN] key → [F2].

The DYN/DLY screen Library page will appear.

Library list

In this page you can load or save dynamics programs from or to the dynamics library. From the library list in the center of the screen, you can select the dynam- ics program that you wish to load or save.

3.Move the cursor to the library list, and rotate the [DATA/JOG] dial to move the cursor location to “011.E.B.Finger.”

Dynamics library numbers 000–040 are read-only programs, and contains stan- dard dynamics settings for frequently used instruments. For this example, we will select a program named “E.B. Finger.”

4.Move the cursor to the RECALL button at the left of the library list, and press the [ENTER] key.

92 — Operation Guide