Yamaha AW4416 manual Start End, Execute

Chapter12—Sampling pads

❍START

❍END

Specify the beginning (START) and end (END) of the area that will be erased from the pad track selected by PAD.

❍EXECUTE

This button executes the Erase command.

Tip!

•If you set the counter to measure units, you can set the START and END parameters in measure/beat units.

•Instead of using the [DATA/JOG] dial to vary a location continuously, you can use the keys of the locate section to move instantly to a desired locate point or marker.

3.Move the cursor to the parameter whose setting you wish to change, and press the [ENTER] key.

The cursor will move to the parameter setting, and the value of the selected parameter will be displayed.

4.Use the [DATA/JOG] dial to set the parameter, and press the [ENTER] key.

The setting will change, and the cursor will return to the parameter location of step 3.

5.Repeat steps 3–4 to set the remaining parameters.

6.Move the cursor to the EXECUTE button and press the [ENTER] key.

A popup window will appear, asking you to confirm the Erase command.

7.To execute the Erase command, move the cursor to the OK button and press the [ENTER] key.

Tip!

You can undo the result of the erasure by pressing the [UNDO] key immediately after executing Erase.

202 — Operation Guide