Yamaha AW4416 Rehearsing and recording with auto punch- in/out, Rehearsing with auto punch-in/out

Chapter7—Punch-in/out

1. Press the [UTILITY] key → [F3] key.

Pre-roll/post-roll time settings

2.Move the cursor to the pre-roll (PREROLL) or post-roll (POSTROLL) fields, and use the [DATA/JOG] dial to set the pre-roll time and post-roll time.

Rehearsing and recording with auto punch- in/out

❒Rehearsing with auto punch-in/out

1.Press the [REC TRACK SELECT] key for the track that you wish to record using auto punch-in/out.

The [REC TRACK SELECT] key will blink, and the track will be in record-ready mode.

2.Make sure that the Locate section [IN]/[OUT] keys are lit, and press the [AUTO PUNCH] key.

The [AUTO PUNCH] key will light, and you will locate to the pre-roll point.

While the [AUTO PUNCH] key is lit, transport/locate operations other than the [STOP]/[PLAY]/[REC] keys cannot be used.

3. To begin rehearsing the auto punch-in/out, press the [PLAY] key.

1 The [PLAY] key will light, and playback will begin from the pre-roll point.

B When you reach the auto punch-in point, the [REC] key will begin blinking, and the monitor signal of the track you selected in step 1 will change from the track playback to the input signal (recording source). However, recording will not actually occur.

C When you reach the auto punch-out point, the [REC] key will go dark, and the monitor signal will return to the track playback. (During rehearsal, record- ing will not actually occur.)

D When you reach the post-roll point, the transport will locate to the pre-roll point and stop.

— Operation Guide 131