Yamaha AW4416 manual Patching to the input channels

8 Patching

This chapter explains how to patch the inputs and outputs, and how to use the Quick Rec function to simultaneously record sixteen channels of input sources.

Patching to the input channels

When the AW4416 is in the default state, input signals are patched to input chan- nels 1–24 as shown in the following diagram. However, you can change the input signals assigned to each input channel as necessary.

			Input
			patch	Mixer section
INPUT jacks 1–8			×8	Input channels 1–8
	OPTION I/O
I/O	slot 1		×8	Input channels 9–16
card	OPTION I/O
I/O	slot 2		×8	Input channels 17–14
card			×2
				Return channel 1
		Effect 1
			×2
				Return channel 2
		Effect 2

Here’s how to patch input signals to input channels 1–24 and return channels 1/ 2.

1.Press the [SETUP] key → [F1] (Patch IN) key.

The display will show the SETUP screen Patch IN page, where you can patch sig- nals to the input channels and recorder inputs. In this page, the MIXER CHAN- NEL INPUT ASSIGN column shows the patched status of input channels 1–24 and return channels 1/2.

Tip!

If the Patch IN tab is not assigned to the [F1] key, press the [SHIFT] key + [F1] key to switch the tabs, and then press the [F1] key.

— Operation Guide 133