
EURO • Printed in England • GB • F016 L69 838 • CLUB/ROYALE • OSW 08/01
CLUB/ROYALE - Buch Seite 6 Dienstag, 7. August 2001 2:41 14
Fault Finding
The following table gives checks and actions that you can perform if your machine does not operate correctly. If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off, remove spark plug cap before investigating fault.
Symptom | Possible Cause | Remedy |
|
|
|
Mower leaves a ragged | Cutter not correctly adjusted | Adjust the cutter |
finish |
|
|
|
|
|
Engine will not start | Engine is flooded | Leave for 10 – 15 minutes |
| Spark plug lead not connected | Reconnect |
| Spark plug dirty | See engine maintenance manual |
| no oil | add oil |
|
|
|
Engine stops | No petrol | Refill tank |
| Engine speed too low for conditions | Move throttle |
| Cutting cylinder obstructed | Turn off engine and clear |
|
| obstruction |
| Engine does not stop | Throttle cable not correctly |
|
| adjusted. Stop engine by removing |
|
| spark plug lead and refer to the |
|
| engine maintenance manual. |
|
|
|
Cutting cylinder does not | Incorrect adjustment | Contact an ATCO Approved |
rotate |
| Service Agent |
|
|
|
Land drive does not | Incorrect adjustment/cable damaged | Contact an ATCO Approved |
engage |
| Service Agent |
|
|
|
Excessive vibration/noise | Blade(s) or/and cylinder bearing damaged | Contact an ATCO Approved |
| Engine fault | Service Agent |
|
| See engine maintenance manual |
|
|
|
18 • F016 L69 838 • TMS • 11.07.01 | English - 6 |