108 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
DHCP Client Configuration Commands
This section describes the commands you can use to configure and manage the
Dynamic Host Configuration Protocol (DHCP) Client operations on your Switch
4500.
debugging dhcp client Syntax
debugging dhcp client { all | error | event | packet }
undo debugging dhcp client { all | error | event | packet }
View
User view
Parameters
all Enter to enable all DHCP client debugging.
error Enter to enable DHCP client error (including packet unrecognizable)
debugging.
event Enter to enable DHCP client event (including address allocation and data
update) debugging.
packet Enter to enable DHCP client packet debugging.
Description
Use the debugging dhcp client command to enable DHCP client debugging.
Use the undo debugging dhcp client command to disable DHCP client
debugging.
By default, DHCP client debugging is disabled.
Example
To enable DHCP client event debugging, enter the following:
<4500>debugging dhcp client event
debugging dhcp xrn xha Syntax
debugging dhcp xrn xha
undo debugging dhcp xrn xha
View
User view
Parameter
None
Description
Use the debugging dhcp xrn xha command to enable DHCP client hot backup
debugging.