3Com 4500 26-PORT manual Reset stp Syntax, Display information, Reset stp interface interfacelist

			RSTP Configuration Commands 217
Times: Hello Time 2 sec,		Max Age	20 sec
Forward	Delay 15 sec, Message Age 0
BPDU sent:	0
TCN: 0,	RST: 0, Config BPDU:		0
BPDU received:	0
TCN: 0,	RST: 0, Config BPDU:		0

Table 27 Display information

Field		Description
Protocol mode		Current Switch is executing RSTP.
The bridge ID (Pri.MAC):		The RSTP configuration of the Switch, including
32768.00e0-fc00-3900		priority and MAC address of local bridge, Configured
The bridge times: Hello Time 2 sec, Max		time parameter (Hello Time, Max Age, Forward
		Delay), priority and MAC address of root bridge, the
Age 20 sec, Forward Delay 15 sec		path cost from this Switch to the root path cost
Root bridge ID(Pri.MAC):		mode, timeout time.
32768.00e0-fc00-3900
Root path cost: 0
Bridge bpdu-protection: disabled
Default path cost standard is dot1t
Timeout factor: 3
Port 2 (Ethernet1/0/2) of bridge is		The RSTP configuration of port 2, including the
DOWN		port’s status is down, the port RSTP is enabled, this
Port spanning tree protocol: enabled		port is Disabled Port, the cost to root of this port ,
		the priority of this port, the priority and MAC address
Port role: Disabled Port		of Designated bridge, this port is configured as a
Port path cost: 200000	Port priority:	non-edge port, the link of this port is
		non-point-to-point, Maximum transmission limit is 3
128
		BPDUs per hello time, configured RSTP time
Designated bridge ID(Pri.MAC):		parameters(Hello Time, Max Age, Forward Delay,
32768.00e0-fc00-3900		Message Age), the statistics of BPDU (TCN specifies
The Port is a non-edged port		the number of topology-change-notify datagram,
		RST specifies the number of RSTP datagram, Config
Connected to a non-point-to-point LAN		BPDU specifies the number of STP datagram)
segment
Maximum transmission limit is 3
Packets / hello time
Times: Hello Time 2 sec,	Max Age 20
sec

Forward Delay 15 sec, Message Age 0

BPDU sent: 0

TCN: 0, RST: 0, Config BPDU: 0

BPDU received: 0

TCN: 0, RST: 0, Config BPDU: 0

reset stp Syntax

reset stp [ interface interface_list ]

View

User view