3Com 4500 26-PORT, 4500 PWR 50-PORT, 4500 50-PORT Display isolate port Syntax, Port isolate Syntax

Access Management Configuration Commands 117

Table 11 Output Description of the display am Command

Field	Description
Status	AM state on the port: enabled or disabled
IP Pools	IP pools. NULL represents no configuration. Each IP address section is
	represented in X.X.X.X (number), of these, "X.X.X.X" represents the
	first address, and "number" represents that "number" consecutive IP
	addresses from the beginning of this address are within the IP pools
Isolate Ports	Isolate ports. NULL represents no configuration

To display the access management configurations on Ethernet1/0/1:

<4500> display am ethernet1/0/1

Ethernet1/0/1
Status	: disabled
IP Pools	: (NULL)

display isolate port Syntax

display isolate port

View

Any view

Parameter

none

Description

Use the display isolate port command to view port isolation information.

Example

To display port isolation information, enter the following:

<4500>display isolate port

Isolated port(s) on UNIT 1:

Ethernet1/0/1

port isolate Syntax

port isolate

undo port isolate

View

Ethernet Port View

Parameter

none

Description

Use the port isolate command to add a port to an isolation group using the following commands, and achieves port-to-port isolation between this port and