3Com 4500 PWR 26-PORT, 4500 50-PORT Using Stack Commands, 4500system-view 4500change self-unit to

9 USING STACK COMMANDS

	This chapter describes how to use the following commands:
	Stack Configuration Commands
	■ change self-unit
	■ change unit-id
	■	display ftm
	■ display xrn-fabric
	■ fabric save-unit-id
	■ fabric-port enable
	■ ftm stacking-vlan
	■ xrn-fabricauthentication-mode
	■	set unit name
	■	sysname
Stack Commands	This section describes how to use the stack configuration commands on your
	Switch 4500.
change self-unit	Syntax
	change self-unit to { <1-8> auto-numbering }

View

System View

Parameter

self-unit:Unit ID of the device.

auto-numbering:Changes the unit ID automatically.

Description

Use the change self-unitcommand to change the unit ID of the current Switch. By default, the unit ID of a Switch is set to 1. A unit ID can be set to a value in the range from 1 to the maximum number of devices supported in the stack.

Example

To change the unit ID of the current Switch to 3, enter the following:

<4500>system-view

[4500]change self-unit to 3