40 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
<SW4500>system-view
System View: return to User View with Ctrl+Z.
[SW4500]user-interface 0 9
[SW4500-ui0-9]
This example command selects two AUX (Console) port user interfaces and two
VTY user interfaces (VTY 0, VTY 1). You can now assign access levels to these
interfaces using the user privilege level command.
user privilege level Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameter
level: Enter the level of command that a user can access, in the range 0 to 3.
Description
Use the user privilege level level command to configure the command level
that a user can access from the specified user interface. The user can use all the
available commands at this command level. Use the undo user privilege level
command to restore the default command level. By default, a user can access all
commands at Level 3 after logging in through the AUX user interface, and all
commands at Level 0 after logging in through a VTY user interface.
Example
To configure a user to access command level 0 after logging in from the VTY 0
user interface, enter the following:
<SW4500>system-view
System View: return to User View with Ctrl+Z.
[SW4500]user privilege level 0
When the user Telnets from the VTY 0 user interface to the switch, the terminal
displays commands at level 0, as shown below:
<SW4500>?
User view commands:
debugging Debugging functions
language-mode Specify the language environment
ping Ping function
quit Exit from current command view
super Privilege current user a specified priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Negate a command or set its default