3Com 4500 PWR 26-PORT Filter-policy export Syntax, Output Description of the display rip Command

RIP Configuration Commands 151

Garbage-collection timer : 120

No peer router

Network : 202.38.168.0

Table 22 Output Description of the display rip Command

Field	Description
RIP is running	RIP is active
Checkzero is on	Zero field checking is enabled
Default cost:1	The default route cost is 1
Summary is on	Routes are summarized automatically
Preference: 100	The preference of RIP is 100
Period update timer : 30	The three RIP timers
Timeout timer : 180
Garbage-collection timer : 120
No peer router	No destination address of a transmission is specified
Network: 202.38.168.0	RIP enabled on network segment 202.38.168.0

filter-policy export Syntax

filter-policy { acl_number gateway gateway-ip ip-prefix ip_prefix_name } export [routing_process]

filter-policy route-policy route-policy-nameexport

undo filter-policy { acl_number gateway gateway-ip ip-prefix ip_prefix-name} export [routing_process]

undo filter-policy route-policy route-policy-nameexport

View

RIP view

Parameters

acl_number Enter the number of the ACL that you want to use to filter the destination addresses of the routing information.

gateway-ip

ip_prefix_name Enter the name of the address prefix list that you want to use to filter the destination addresses of the routing information.

route-policy-name: Route policy name that filters routing information. After enabling RIP protocol, you can determine which routes are to be sent/received based on acl/cost/interface/ip/ip-prefix/tag fields.

routing_protocol Enter the routing protocol whose routing information is to be filtered. This can be one of the following:

■direct — Specifies direct routes

■static — Specifies static routes.