3Com 4500 PWR 50-PORT manual Stp Syntax, 4500reset stp interface Ethernet1/0/1 to Ethernet1/0/3

218CHAPTER 10: USING RSTP COMMANDS

Parameter

interface interface_list: Specifies the Ethernet port list, including multiple Ethernet ports. Expressed as interface _list = { { interface_type

interface_num interface_name } [ to { interface_type interface_num interface_name } ] }&<1-10>.

For details about interface_type, interface_num and interface_name, refer to the port command in this guide.

&<1-10>:Indicates the preceding parameter can be input up to 10 times.

Description

Use the reset stp command to reset the statistics information about Rapid

Spanning Tree Protocol (RSTP).

This command can be used to clear the statistics information about a specified port. If no port is specified, the statistics information of all the ports of the device will be cleared.

Related command: display stp.

Example

To clear the statistics information about Ethernet1/0/1 through Ethernet1/0/3, enter the following:

<4500>reset stp interface Ethernet1/0/1 to Ethernet1/0/3

stp Syntax

stp { enable disable }

undo stp

View

Ethernet Port View

Parameter

enable: Enables RSTP on a device or a port.

disable: Disables RSTP on a device or a port.

Description

Use the stp enable command to enable RSTP on a device or port.

Use the stp disable command to disable RSTP on a device or port.

Use the undo stp command to disable RSTP on a device.

By default, RSTP is enabled on the Switch and all ports.

If the parameters of RSTP have not been set for the device or the ports before

RSTP is enabled on the device, they will take the default values. Before or after

RSTP is enabled, you can use the configuration command to set RSTP parameters