3Com 4500 50-PORT, 4500 PWR 50-PORT To create manual aggregation group 22, enter the following

72CHAPTER 2: USING PORT COMMANDS

manual: Manual aggregation group.

static: Static aggregation group.

Description

Use the link-aggregation group agg_id mode command to create a manual or static aggregation group. Use the undo link-aggregation group command to delete an aggregation group.

The Switch will select the lowest port number as the master port for the link aggregation. This applies to all types of link aggregation. If the aggregation spans a stack of units and the same ports are used, the unit number will be the tie-breaker. For example, 1/0/1 and 2/0/1 are in an aggregation. Port 1/0/1 will be the master port.

A manual or static aggregation group can have up to eight ports. You can use the link-aggregation group agg-idmode command to change an existing dynamic aggregation group into a manual or static one. If the port number in a group exceeds eight, this operation fails and the system prompts you about the configuration failure.

Related command: display link-aggregation summary.

Example

To create manual aggregation group 22, enter the following:

<4500>system-view

System View: return to User View with Ctrl+Z.

[4500]link-aggregation group 22 mode manual

port link-aggregation group

Syntax

port link-aggregation group agg_id

undo port link-aggregation group

View

Ethernet Port View

Parameter

agg_id: Aggregation group ID, in the range of 1 to 416.

Description

Use the port link-aggregation group agg_id command to add an Ethernet port into a manual or static aggregation group. Use the undo port link-aggregation group command, to delete an Ethernet port from a manual or static aggregation group.

Related command: display link-aggregation verbose.

Example

To add Ethernet1/0/1 into aggregation group 22, enter the following:

<4500>system-view