Resetting the Switch 2000 TR

This section provides instructions for resetting the Switch 2000 TR.

Because some configurable parameters require that you reset the Switch 2000 TR after making changes, it is important to understand the reset procedure before proceeding.

You have four different ways to reset the Switch 2000 TR:

VT100 Console

LCD Console

Reset button

Power cycle

VT100 Console Reset

The Switch 2000 TR must be reset after making cer- tain changes using the VT100 interface. You may make more than one change before committing them to memory by resetting.

To reset the Switch 2000 TR from the VT100 interface when you have made changes, take these steps:

1Select RESET from the Switch 2000 TR Main Menu.

The Switch 2000 TR TR Reset screen appears. See Figure 3-15.

2Select OK to confirm the reset or CANCEL to stop the reset. If you select OK you will be prompted to con- firm again.

Resetting the Switch 2000 TR

3-21

The Switch 2000 TR resets.

Figure 3-15Switch 2000 TR Reset Screen

LCD Console Reset

When you make certain parameter changes using the front panel LCD console, you must commit them to system memory by performing a reset.

To reset the Switch 2000 TR using the LCD, proceed as follows:

1Press [Up or Down Arrow] until Switch 2000 TR>Reset appears.

2Press [Enter].

The Confirm RESET? screen appears.

3Press [Enter] to confirm.

If you decide not to reset at this point you may press [Left Arrow] to cancel and return to the previous screen.

The Switch 2000 TR resets.

Page 57
Image 57
3Com manual Resetting the Switch 2000 TR, VT100 Console Reset, LCD Console Reset