Route Plan Configuration Requirements 273
In both cases, one server in the pair is designated the primary and the
other server is designated the secondary.
In a single-site system, you need to configure end points, routes,
patterns, and route plans on the primary server running call processing
software.
■You need to create end points that identify the other call processor
and the IP Messaging modules.
■You need to define routes containing the appropriate call processor
and IP Messaging end points.
■You need to define one or more dial string patterns. A pattern
identifies the dial string prefix used by an end point. A pattern is
associated with a route and indicates which end point should receive a
call.
■You need to create route plans (associate a route with a dial string
pattern) on both call processing servers. This enables each call
processor to route a dialed number to the correct destination (end
point).
Example
For example, a VCX single-site system includes two redundant, IP
Telephony and IP Messaging VCX servers, A and B. A is the primary
server, B is the secondary server.
Note that the following steps reference other topics in this chapter that
describe how to configure a route plan and its elements (end points,
patterns, and routes). You can also use the Route Plan Wizard to create a
route plan and its elements. See Using the Route Plan Wizard.
The following steps configure the required routes on VCX server A.
1Access the server you want to manage (see Accessing a VCX Site through
the Central Manager).
The USERS interface is enabled and the Users page appears.
2Click DIRECTORY.
3Create four end points.
aAdd an end point of the type Call Processor that points to A.
bAdd an end point of the type Call Processor that points to B.