310 CHAPTER 10: CONFIGURING ROUTING AND TRANSLATION SERVICES
dSelect the new route plan by enabling the radio button preceding the
route plan name.
eClick Next (lower right corner of the Wizard page).
The second page of the Route Wizard appears. See Figure 119.
Figure 119 Route Plan Wizard - Page 2
As shown in Figure 119, the page lists previously configured end points.
You have the following two options:
■You can create an end point, then add it to the route plan. Go to
step 3.
■You can add an existing end point to the route plan. Got to step 4.
3To create an end point:
aEnter a name for the end point in the Name text box.
bEnter the site identifier for this end point in the Site Id text box. The
site ID is typically the pattern (prefix) dialed by a caller to reach a
regional or branch office.
cThe IP Port field specifies the port number used by the end point. The
default port number is 5060.
■If this end point identifies an IP Telephony and IP Messaging server,
or an IP Telephony server, accept the default port number 5060.