AT&T 75 manual Ringer Volume Control Area Enhanced Console Only, Stored Number

CHAPTER 2. DESCRIPTION

•lntgrtd Directory (integrated Directory)

Displays names and extension numbers from system directory.

Ž Stored Number

.

Displays the trunk access code or the extension number of the facility being monitored by a Busy (Facility Busy Indication) button. This is accomplished by pressing the Stored Number button followed by the Busy button.

Ringer Volume Control Area (Enhanced Console Only)

The ringer volume control area on the Enhanced Attendant Console is shown in Figure 2-12a.This area consists of an Up button (labeled with an up arrow), a Down button (labeled with a down arrow), and a Select button. Three different ringer volumes can be adjusted. These are the incoming calls, calls waiting, and timed reminder tone volumes. These are the same volumes that are adjusted by the three slide switches located on the front panel of the Basic Attendant Console. Ringer volume can be adjusted for each of these tones in either of the following two conditions:

•While the ringer is on (tone is present).

Pressing and releasing the Up or Down button, while the appropriate tone is present, varies the volume of the tone. When this is done, a bar graph appears on the attendant display, along with the name of the tone. The bar graph shows the volume level of the tone being heard. To change a tone volume, push one of the volume control buttons several times while the tone is present. As this is done, the volume and the bar graph will change. Holding the button after pushing does not affect tone volume any more than a quick push and release.

•While the ringer is off.

To change the ringer volume while a tone is not present, simply press and release the Up or Down button. When this is done, a bar graph appears on the attendant display, along with the name of the tone. The bar graph shows the volume level of the tone indicated on the display. The volume of that tone can be changed by pressing and releasing the Up or Down button the required number of times. As this is done, the bar graph will change.

The first ringer volume that is displayed when the Up or Down button is pressed is the “incoming calls” ringer volume. The display will show “incoming call volume” along with the bar graph. While the incoming calls volume is displayed, the volume of the other two tones may be changed by first pressing the Select button (once for the Timed Reminder tone or twice for the the Call Waiting tone) and then pressing the Up or Down button the appropriate number of times.

The Select button is used to select the tone for which you wish to change the volume. As this button is pressed, the display is updated with the tone name and the volume level bar graph. However, this button only functions as the Select button while ringer volume information is displayed. Otherwise, the Select button serves as

2 - 30