Black Box LGB1108A, LGB1126A, LGB1148A, Managed Gigabit Switch manual Configuration

Chapter 3: Configuration

•Timer Values: To set the GARP join timer, leave timer, and leave all timers, the unit is microseconds (ms). Three different timers can be configured on this page:

-Join Timer: The default value for Join timer is 200 ms.

-Leave Timer: The range of values for Leave Time is 600–1000 ms. The default value for Leave Timer is 600 ms.

-Leave All Timer: The default value for Leave All Timer is 10000 ms.

•Application: Currently only supported application is GVRP.

•Attribute Type: Currently only supported Attribute Type is VLAN.

•GARP Applicant: This configuration is used to configure the Applicant state machine behavior for GARP on a particular port locally.

-normal-participant: In this mode the Applicant state machine will operate normally in GARP protocol exchanges.

-non-participant: In this mode the Applicant state machine will not participate in the protocol operation.

The default configuration is normal participant.

•Buttons:

-Save: Click to save changes.

-Reset: Click to undo any changes made locally and revert to previously saved values

LGB1108A 724-746-5500 blackbox.com Page 127