Chapter 3: Configuration
3.1.6 SFP Information
This section describes the SFP module detail information, including connector type, fiber type, wavelength, baud rate, and vendor OUI, etc.
Web Interface
To display the SFP information in the Web interface:
1.Click Configuration, Port, then SFP Information
2.To display the SFP Information.
Figure 3-6. The SFP Information Overview screen.
Parameter Description
•Connector Type: Displays the connector type: UTP, SC, ST, LC etc.
•Fiber Type: Displays the fiber mode, for instance, Multi-Mode, Single-Mode.
•Tx Central Wavelength: Displays the fiber optical transmitting central wavelength: 850nm, 1310nm, 1550nm etc.
•Baud Rate: Displays the maximum baud rate of the fiber module supported, for instance, 10M, 100M, 1G etc.
•Vendor OUI: Displays the Manufacturer’s OUI code, which is assigned by IEEE.
•Vendor Name: Displays the company name of the module manufacturer.
•Vendor P/N: Displays the product name of the naming by module manufacturer.
•Vendor Rev (Revision): Displays the module revision.
•Vendor SN (Serial Number): Displays the serial number assigned by the manufacturer.
•Date Code: Displays the date this SFP module was made.
•Temperature: Displays the current temperature of the SFP module.
•Vcc: Displays the working DC voltage of the SFP module.
•Mon1 (Bias) mA: Displays the bias current of the SFP module.
•Mon2 (TX PWR): Displays the transmit power of the SFP module.
•Mon3 (RX PWR): Displays the receiver power of the SFP module.
LGB1108A | Page 47 | |
|
|
