Chapter 4: Security

Parameter Description

Mode of IP Source Guard Configuration: Enable the Global IP Source Guard or disable the Global IP Source Guard. All configured ACEs will be lost when the mode is enabled.

Port Mode Configuration: Specify on which ports IP Source Guard is enabled. Only when both Global Mode and Port Mode on a given port are enabled is IP Source Guard enabled on that port.

Max Dynamic Clients: Specify the maximum number of dynamic clients that can be learned on given port. This value can be 0, 1, 2 or unlimited. If the port mode is enabled and the value of max dynamic client is equal to 0, it means it only allows the IP packets forwarding that are matched in static entries on the specific port.

Buttons:

-Save: Click to save changes.

-Reset: Click to undo any changes made locally and revert to previously saved values.

4.1.2 Static Table

This section describes how to configure the Static IP Source Guard Table parameters of the switch. The Static IP Source Guard Table enables you to configure and to manage the entries.

Web Interface

To configure a Static IP Source Guard Table Configuration in the Web interface:

1.Click “Add new entry.”

2.Specify the Port, VLAN ID, IP Address, and MAC address in the entry.

3.Click “Save.“

Figure 4-2. The Static IP Source Guard Table screen.

Parameter Description

Delete: Check to delete the entry. It will be deleted during the next save.

Port: The logical port for the settings.

VLAN ID: The VLAN ID for the settings.

IP Address: Valid source IP address.

LGB1108A

724-746-5500 blackbox.com

Page 167

 

 

Page 167
Image 167
Black Box LGB1108A, LGB1126A, LGB1148A, Managed Gigabit Switch manual Security