Chapter 3: Configuration
Selecting “Weighted“ mode will display this screen instead of that shown in Figure
Figure
Parameter Description
•Port: The logical port for the settings contained in the row. Click on the port number to configure the shapers.
•Shapers (Qn): Shows “disabled“ or actual queue shaper rate, e.g. “800 Mbps.“
•Shapers (Port): Shows “disabled“ or actual port shaper rate, e.g. “800 Mbps.“
•Scheduler Mode: Controls whether the scheduler mode is “Strict Priority“ or “Weighted“ on this switch port.
•Queue Shaper Enable: Controls whether the queue shaper is enabled for this queue on this switch port.
•Queue Shaper Rate: Controls the rate for the queue shaper.
•Queue Shaper Unit: Controls the unit of measure for the queue shaper rate as “kbps“ or “Mbps.“ The default value is “kbps.“
•Queue Shaper Excess: Controls whether the queue is allowed to use excess bandwidth.
•Queue Scheduler Weight: Controls the weight for this queue. The default value is “17.“ This value is restricted to
•Queue Scheduler Percent: Shows the weight in percent for this queue. This parameter is only shown if “Scheduler Mode“ is set to “Weighted.“
•Port Shaper Enable: Controls whether the port shaper is enabled for this switch port.
•Port Shaper Rate: Controls the rate for the port shaper.
•Port Shaper Unit: Controls the unit of measure for the port shaper rate as “kbps“ or “Mbps.“ The default value is “kbps.“
•Buttons:
-Save: Click to save changes.
-Reset: Click to undo any changes made locally and revert to previously saved values.
Page 138 | LGB1108A | |
|
|