Bosch Appliances 7000 manual Cleaning the Bubble Exterior, Remove an SD card

156 en Maintenance AutoDome 7000 Series (IP and HD)

Cleaning the Bubble Exterior

The exterior of the bubble is hard coated for extra protection. If cleaning becomes necessary, only use cleaning solutions and cloths suitable for cleaning safety glass lenses. Dry the bubble thoroughly with a dry nonabrasive cloth to prevent water spots. Never scrub the bubble with any abrasive material or cleaners.

Bosch recommends cleaning the exterior of the bubble with NOVUS “No. 1” Plastic Clean & Shine (or equivalent), according to manufacturer’s instructions. Refer to www.novispolish.com to order or to find a local distributor.

Cautions

–Do Not clean bubbles in the hot sun or on very hot days.

–Do Not use abrasive or highly alkaline cleaners on the bubble.

–Do Not scrape the bubble with razor blades or other sharp instruments.

–Do Not use Benzene, Gasoline, Acetone, or Carbon Tetrachloride on the bubble.

Remove an SD card

1.Follow the steps in one of these sections (depending on the type of camera mount): Remove the bubble from an in-ceiling housing, page 67 or Remove the bubble from a pendant housing, page 67.

2.Press down the end of the SD card until it ejects partially from the connector.

3.Pull out the SD card and put it in a safe location.

4.Follow the steps in one of these sections (depending on the type of camera mount): Replace the bubble in an in-ceiling housing, page 69 or Replace the bubble in a pendant housing, page 69.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems