Bosch Appliances 7000 manual Installing the VGA-ROOF-MOUNT, Vga-Roof-Mount

AutoDome 7000 Series (IP and HD) Installing the Roof Parapet and Pipe Mounts en 47

	Notice!
	After all wiring is complete, close the cover door and tighten the two (2) captive screws on
	the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is watertight.
8.4	Installing the VGA-ROOF-MOUNT
	This section details the installation steps for the Roof Parapet Mount. If you are installing a
	pipe mount, refer to Installing the VG4-A-9543 Pipe Mount, page 49 for instructions.

Figure 8.6: VGA-ROOF-MOUNT

1.Determine the wall location on the roof for the camera and use the Parapet wall mount bracket as a template to mark the hole locations.

Notice!

Allow enough room below the Parapet Mount Bracket to route the video, control and alarm wires up through the Parapet arm. In certain installations you may have to lift the Parapet arm for the camera to clear the top of the wall when it is swung into position. Provide enough slack in the wires to rotate the pipe arm over the roof and back when camera maintenance is required.

2.Prepare the mounting surface for the type of fastener by drilling holes for the mounting anchors as required.

Figure 8.7: Parapet Wall Mount Bracket and Roof Mount Plate

1	Pipearm	4	Apply sealant around each fastener hole
2	Parapet Wall Bracket	5	Roof Mount Plate
3	3/8-16 SS Hex Head Bolt	6	Use a minimum of six (6) fasteners (not
	(supplied)		supplied). Eight (8) fastener holes shown.

Bosch Security Systems Operation Manual 2013.07 1.2.2 F.01U.283.679