AutoDome 7000 Series (IP and HD)

Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 35

 

 

4.Once you have the hinges aligned, release the top hinge pin to engage its mating hinge on the Mounting Plate. Then release the bottom hinge pin from the Hinge Pin Stop to lock the Pendant Arm to the Mounting Plate.

Route and Connect Wires to a Power Supply Box

The illustration below depicts the power and control cables connected to the Pendant Arm:

Figure 7.10: Pendant Arm Cables

 

 

Cable

 

Cable

 

 

 

 

 

 

1

Grounding Strap (black)

5

UTP Video/Ethernet (blue)

 

 

 

 

 

 

2

24 VAC Power (red)

6

Alarm Outputs (white)

 

 

 

 

 

 

3

Relay Contacts (yellow)

7

Alarm Inputs (gray)

 

 

 

 

 

 

4

Coax Video (black)

8

Serial Communications (green)

 

 

(Not applicable for AUTODOME

 

Used for Audio Input/Output in

 

 

7000 Series cameras)

 

AUTODOME 7000 Series.

 

 

 

 

 

 

 

 

 

 

Notice!

Refer to the Connection, page 70 chapter for wire specifications and distances.

1.Route all incoming wires through one of the earth-grounded conduits at the bottom of the Mounting Plate. For a mast mount, route all wires through the right-angle conduit.

2.Attach the water-tight plug to the other conduit.

3.Attach the grounding spade terminal (item 1, below) to one of the spade terminals inside the Mounting Plate.

Bosch Security Systems

Operation Manual

2013.07 1.2.2 F.01U.283.679

Page 35
Image 35
Bosch Appliances 7000 manual Route and Connect Wires to a Power Supply Box, Pendant Arm Cables