Bosch Appliances 7000 manual VG4-PA0 Power Supply Box

30 en Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AutoDome 7000 Series (IP and HD)

Warning!

Ensure that you connect the outgoing power supply wires to the P107 heater connectors (HN

! and HL). The heater power (XF103) fuse can handle a higher amperage (3.15 A) than the camera power (XF102) fuse (2.0 A).

6. Route the 24 VAC outgoing power supply wires into the VG4-PA0 power supply box through the conduit fitting on the left side of the box.

7. Cut and trim the 24 VAC power and ground wires with sufficient slack to reach their connector terminal in the box, but not so long as to be pinched by or to obstruct closing the cover door.

8. Attach the supplied 3-pin power plug to the incoming 24 VAC power wires in the box, as illustrated below.

J101

(FUSE) XF101

P101

24V NC 24V

1 2 3

P106

GND TXD RXD C+ C-

6 5 4 3 2 1

J102		XF103
P107	HTRDOME	5 4 3 2 1
	J103	XF102
	(LED)

P105

GND TXD RXD C+ C-

6 5 4 3 2 1

(FUSE)(FUSE)

Figure 7.6: VG4-PA0 Power Supply Box

1

2

3

4

Incoming 24 VAC Power Supply Wires (from VG4-PSU1/VG4-PSU2 power supply box)

Ground Wire

P101 Connector

Control Data and Video In/Out Wires

4Follow the instructions in Attach Pendant Arm to Power Supply Box, page 31 to continue the installation.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems