Bosch Appliances 7000 manual Attach Pendant to Arm and Tighten

AutoDome 7000 Series (IP and HD) Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 37

14.Attach the 6-pin serial communication mating connector to the Serial Communications cable (cable 8).

15.Connect the Earth ground wire, if available, to the crimp ring terminal inside the Mounting Plate.

Note: The Earth ground is not provided with the VGA-PEND-WPLATE kit; it is a ground connection made at the installed location.

16.After making the harness connections to the Mounting Plate, rotate the Pendant Arm to close and tighten the two (2) captive screws to 10‑12 N-m (90-105 in.-lbs).

Notice!

After all wiring is complete, close the cover door and tighten the two (2) captive screws on the cover door to 10-12 N-m (90-105 in.-lbs).

7.7 Attach Pendant to Arm and Tighten

Notice!

Before attaching the AUTODOME Pendant, visually inspect the dome and arm connectors for any blocked pin holes or bent pins.

1.Tilt the bottom of the dome toward the pendant arm base and place the mounting hook, located on top of the dome housing, over the recessed hinge pin of the arm.

Bosch Security Systems Operation Manual 2013.07 1.2.2 F.01U.283.679