Bosch Appliances 7000 manual Pin Description Alarm Out Normally Open, Com

AutoDome 7000 Series (IP and HD) Installing the Roof Parapet and Pipe Mounts en 53

The Pipe Interface Board contains all of the connectors for control, data, image, and power wires. Follow the procedures below to make the proper connections.

Warning!

! Use a 24 VAC Class 2 power supply only.

1. Attach an RJ45 connector plug to the Ethernet cable and connect the plug to its mating connector J101 on the Pipe Interface Board.

2. Attach the control data in/out wires to their respective terminals on the P105 connector on the Pipe Interface Board.

3. Connect the 24 VAC power wires to the P101 connector on the Pipe Interface Board. If this model has a heater, connect the 24 VAC heater power wires to connector P107.

Caution!

!To protect the camera from damage due to cold temperatures, ensure that you connect the 24 VAC heater power wires to the P101 connector.

Connecting Alarm Inputs and Outputs

4 To connect alarm inputs and outputs, attach the supplied 6-pin Alarms In and the 4-pin Alarms Out connector plugs with flying lead wires to the appropriate incoming alarm wires. Alarm Out 4 is a relay.

PIN

1
	WHITE
2
	BROWN
3
	ORANGE
4
	GREEN
PIN
1
	WHITE
2
	BROWN
3
	ORANGE
4
	GREEN
5
	YELLOW
6
	BLUE

Figure 8.12: Alarm and relay connectors

P102

P103

N.O. COM N.C. A1 A2 GND

P104

1

2

3

4

5

6

7

1	4-pin Alarm	2	6-pin Alarm In	3	7-pin Relay Connector (P104)
	Connector (P102)		Connector (P103)
Pin	Description	Pin	Description	Pin	Description
1	Alarm Out 1	1	Alarm in 3	1	Alarm Out 4	Normally Open
2	Alarm Out 2	2	Alarm in 4	2	Alarm Out 4	COM
3	Alarm Out 3	3	Alarm in 5	3	Alarm Out 4	Normally Closed
4	Alarm Ground	4	Alarm in 6	4	Earth Ground
		5	Alarm in 7	5	Analog Alarm 1
		6	Alarm Ground	6	Analog Alarm 2

Bosch Security Systems Operation Manual 2013.07 1.2.2 F.01U.283.679