Bosch Appliances 7000 manual Make Connections in the Power Supply Box

32 en Installing the Pendant Arm Wall, Corner, and Mast (Pole) MountsAutoDome 7000 Series (IP and HD)

7.5 Make Connections in the Power Supply Box

1 2 3

Figure 7.8: Pendant Arm connections to Power Supply Box

1.Attach the earth ground wire (item 1 in the illustration above) to the grounding screw on the left side of the power box.

2.Connect the 6-pin Control In/Out Plug, installed previously, to its mating connector P106 in the power box.

3.Connect the 6-pin Control to Dome Plug from the Pendant Connector Harness to its mating connector P105 in the power box.

4.Connect the 5-pin, 24 VAC to Dome Plug from the Pendant Connector Harness to its corresponding color mating connector P107 on the right side of the box.

5.To connect alarm inputs and relay outputs, connect the 4-pin Alarms Out, the 6-pin Alarms In, and the 7-pin Relay connectors from the Pendant Connector Harness to their mating connectors, installed previously, to the incoming alarm wires.

6.Connect the 3-pin Power In Plug, installed previously, to its mating connector P101 on the left side of the box.

7.Connect the incoming RJ45 video connector, installed previously, to its mating connector from the Pendant Connector Harness.

8.Attach the grounding strap of the Pendant Arm to the Power Supply Box.

9.After making the harness connections to the Power Supply Box, rotate the Pendant Arm to close and seal the Power Supply Box and tighten the two (2) captive screws to 10‑12 N-m (90-105 in.-lbs).

10.Refer to Attach Pendant to Arm and Tighten, page 37 to continue the installation procedure.

Notice!

After all wiring is complete, close the cover door and tighten the two (2) captive screws on the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is watertight.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems