36 en Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts

AutoDome 7000 Series (IP and HD)

 

 

Figure 7.11: Mounting Plate - Inside Detail

Ref.

Description

1Grounding lug with two spade terminals

2Earth ground lug with crimp ring terminal

3Wire input conduit holes

4.Connect the incoming 24 VAC power wires to the 5-pin, 24 VAC Power In mating connector (supplied with the Mounting Plate kit) for the camera and for the Heater.

5.Attach the grounding spade from the 5-pin mating connector to the other spade terminal inside the mounting plate.

6.Attach the 5-pin Power In mating connector to the 24 VAC Power cable (cable 2) connected to the pendant.

7.Remove the mating connector from the Relay Contacts cable (cable 3).

8.Connect the incoming relay contact wires to the mating connector. Then, reattach the mating connector to the Relay Contacts cable.

9.Attach an RJ45 plug to the incoming UTP cable.

10.Connect the incoming RJ45 video connector, installed previously, to the UTP Video/ Ethernet cable (cable 5).

11.Connect the outgoing alarm wires to the flying leads coming from the 4-pin Alarm Outputs cable (cable 6).

12.Connect the incoming alarms wires to the flying leads coming from the 6-pin Alarm Inputs cable (cable 7).

13.Connect the incoming serial communication wires to the 6-pin mating connector supplied with the VGA-PEND-WPLATE kit. Refer to the Power Supply Box Connections table above for details.

2013.07 1.2.2 F.01U.283.679

Operation Manual

Bosch Security Systems

Page 36
Image 36
Bosch Appliances 7000 manual Mounting Plate Inside Detail