Bosch Appliances 7000 manual Advanced Mode Interfaces Alarm Inputs, Alarm Outputs

128 en Configuration via IP, Advanced Mode AutoDome 7000 Series (IP and HD)

14.39Advanced Mode: Interfaces

14.40Alarm Inputs

Select the type of input for each physical alarm. Select from either N.O. (Normally Open) or N.C. (Normally Closed) and provide an optional name for each input.

14.41Alarm Outputs

The camera incorporates three (3) open collector alarm or transistor outputs. Use the following settings to configure the relay for alarm outputs.

Idle state

Specify either Open or Closed idle state.

Operating mode

Select one of the following modes for operation: Bistable, 0.5 s, 1 s, 5 s, 10 s, or 60 s.

Output name

Type an optional name for the relay connection, up to 20 characters.

Trigger output

Click the appropriate Trigger output button to test the relay / output connection.

14.42Advanced Mode: Network

14.43Network Access

The settings on this page are used to integrate the camera into an existing network.

Some changes only take effect after the unit is rebooted. In this case, the Set button changes to Set and Reboot.

1.Make the desired changes.

2.Click the Set and Reboot button. The camera reboots and the changed settings are activated.

Caution!

!If you change the IP address, subnet mask or gateway address, the camera is only available under the new addresses after the reboot.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems