Bosch Appliances 7000 manual Tilt up, Hook and drop, Recessed Hinge Pin, Dome Connector

38 en Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AutoDome 7000 Series (IP and HD)

A

B

Figure 7.12: Attach Pendant to Arm

1	Tilt up.
2	Hook and drop.
2a	Recessed Hinge Pin
2b	Dome Connector
3	Rotate down to engage dome connector.
4	Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs).

2.Drop the dome housing down slightly to engage the dome housing hook on the Pendant Arm hinge pin, allowing the dome to rotate around the pin.

3.Rotate the dome housing down to a vertical position and gently push upward to engage the connector on top of the dome housing.

Caution!

!If you feel any resistance when rotating the dome housing or when engaging the connector, stop immediately and start over.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems