68 en Preparing the Bubble

AutoDome 7000 Series (IP and HD)

 

 

Figure 10.2: Pendant Bubble Release Opening

3.Firmly rotate the bubble counterclockwise approximately 20 degrees until the bubble assembly releases from the Pendant Housing.

Replace the trim ring (optional) (In-ceiling models)

The dome bubble for in-ceiling models of AUTODOME 7000 comes assembled with a white trim ring. An optional black trim ring is supplied in the shipping box. To replace the white trim ring, follow these steps:

1.Remove the four (4) Phillips head screws from the inner ring.

2.Remove the white trim ring.

3.For In-ceiling models, verify that the trim ring gasket is in place. (Refer to the graphic in Installing the Ceiling (IP54 Housing) Gasket, page 63 for an illustration of the correct placement of the gasket.)

4.Place the black trim ring over the inner ring.

5.Replace and tighten the four (4) screws.

2013.07 1.2.2 F.01U.283.679

Operation Manual

Bosch Security Systems

Page 68
Image 68
Bosch Appliances 7000 manual Replace the trim ring optional In-ceiling models, Pendant Bubble Release Opening