Bosch Appliances 7000 manual Ground Screw P101 Connector Power In 120 VAC, Vac

26 en Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AutoDome 7000 Series (IP and HD)

TRANSFORMER (115/230VAC

MODELS)

J10 1

)	XF101
(FUSE

P101

LINE NC NEUT

1 2 3	P106
	GND TXD RXDC+ C-

6 5 4 3 2 1

J102			XF103
P107	HTRDOME	5 4 3 2 1
A			XF102
J103
(LED)

P105

GND TXD RXD C+ C-

6 5 4 3 2 1

(FUSE)(FUSE)

Figure 7.2: Pendant arm power supply box

1	Ground Screw	7	P101	Connector; Power In (120 VAC / 220
			VAC)
2	From Harness (Nexus cable bundle)	8	P106	Connector; Control In/Out for external
			audio input and output
3	In/Out; 1/2 in. (15 mm) NPS Fitting	9	P105	Connector; Audio to camera
4	Ethernet connector	10	Power In; 3/4 in. (20 mm) NPS Fitting
5	P107 Connector; 24 VAC to camera	11	Audio Input/Output; 3/4 in. (20 mm) NPS
			Fitting (labeled “SERIAL COMMUNICATIONS”)
6	In/Out; 1/2 in. (15 mm) NPS Fitting

Warning!

In earlier Bosch AUTODOME cameras, cable 8 in the ARM mount is labeled “Control In/Out” and was used for external RxD/TxD and Biphase communications. In the AUTODOME 7000

! Series cameras: If you are mounting an AUTODOME 7000 Series camera to an ARM mount that was wired for an earlier model of Bosch AUTODOME, you must either re-wire cable 8 to be audio input and output, or disconnected it from the power supply.

Cables/wires that are routed through number 2 in the illustration above come from the Nexus cable bundle that is in the pendant Arm.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems