Bosch Appliances 7000 manual Preparing the Bubble, Remove the bubble from an in-ceiling housing

AutoDome 7000 Series (IP and HD)Preparing the Bubble en 67

10 Preparing the Bubble

The inside of the housing may contain packing material to safeguard the camera during shipping. If so, you must remove the packing material before attaching the in-ceiling housing to the interface box.

Notice!

To avoid excessive moisture saturation inside the housing, limit the amount of time that the bubble is disconnected from the housing. Bosch recommends that the bubble be removed from the housing for no more than five (5) minutes.

Remove the bubble from an in-ceiling housing

1.Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or smaller Phillips screwdriver until the bubble can rotate freely.

2.Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from the In-Ceiling Housing. See the figure below for an illustration.

Figure 10.1: Bubble Release Screw

3.Remove the foam inserts surrounding the camera module.

Remove the bubble from a pendant housing

1.Using both hands, apply a firm counterclockwise (looking up at the dome) rotational force on the Pendant Bubble Assembly to set the bubble latch.

2.Insert a small (2 mm) straight blade screw driver into the release opening in the bubble trim-ring to release the lock, and then remove the screwdriver.

Bosch Security Systems Operation Manual 2013.07 1.2.2 F.01U.283.679