Bosch Appliances 7000 manual Basic Mode Date/Time, Basic Mode Network

AutoDome 7000 Series (IP and HD)Configuration via IP, Basic Mode en 85

13.2	Basic Mode: Date/Time
	Device date/Device time/Device time zone
	If there are multiple devices operating in your system or network, it is important to
	synchronize their internal clocks. For example, it is only possible to identify and correctly
	evaluate simultaneous recordings when all units are operating on the same time. If necessary,
	you can synchronize the unit with your computer's system settings.
	Notice!
	Ensure that recording is stopped before synching to the PC.
	4 Click the Sync to PC button to copy your computer's system time to the camera.
	Time server IP address
	The camera can receive the time signal from a time server using various time server protocols,
	and then use it to set the internal clock. The unit polls the time signal automatically once every
	minute.
	4 Enter the IP address of a time server here.
	Time server type
	Select the protocol that is supported by the selected time server. Preferably, you should
	select the SNTP server as the protocol. This supports a high level of accuracy and is required
	for special applications and subsequent function extensions.
	Select Time server for a time server that works with the protocol RFC 868.
13.3	Basic Mode: Network

The settings on this page are used to integrate the camera into an existing network.

Some changes only take effect after the unit is rebooted. In this case, the Set button changes to Set and Reboot.

1. Make the desired changes.

2. Click the Set and Reboot button. The camera reboots and the changed settings are activated.

Caution!

!If you change the IP address, subnet mask or gateway address, the camera is only available under the new addresses after the reboot.

DHCP

If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you can activate acceptance of IP addresses automatically assigned to the camera. Certain applications (VIDOS, Bosch Video Management Systems, Archive Player, Configuration Manager) use the IP address for the unique assignment of the unit. If you use these applications, the DHCP server must support the fixed assignment between IP address and MAC address, and must be appropriately set up so that, once an IP address is assigned, it is retained each time the system is rebooted.

IP address

Enter the desired IP address for camera in this field. The IP address must be valid for the network.

Subnet mask

Enter the appropriate subnet mask for the selected IP address here.

Bosch Security Systems Operation Manual 2013.07 1.2.2 F.01U.283.679