Bosch Appliances 7000 manual Secure Housing to Ceiling, Secure camera to ceiling

66 en Installing the In-Ceiling Mount AutoDome 7000 Series (IP and HD)

Caution!

The In-ceiling dome is provided with tether points on each side of the housing. To prevent

! injury, attach a safety wire from a secure anchor point above the ceiling to a tether point on the dome housing. See below for an illustration.

9.9 Secure Housing to Ceiling

The In-ceiling Housing is secured to the ceiling by two (2) screw clamps.

1.Insert the In-ceiling Mount Assembly through the hole in the ceiling.

2.Tighten both clamps using a #2 Phillips screwdriver, to secure the housing to the ceiling.

40 MM

1.57 IN.

MAXIMUM CEILING

6.5MM

0.26IN.

MINIMUM CEILING

MM

INCHES

Figure 9.12: Secure camera to ceiling

1	Tether Point	4	Ceiling Clamp
2	Ceiling Clamp	5	Rotate Clockwise to Engage Clamp
3	Tether Point

Caution!

Over-torquing the Ceiling Clamps can damage the clamp or ceiling. Only tighten the clamp

! until it contacts the ceiling and you start to feel some resistance. If using a power screwdriver, set the torque level to the lowest setting.

2013.07 1.2.2 F.01U.283.679 Operation Manual Bosch Security Systems