AutoDome 7000 Series (IP and HD)Configuration en 83

 

Caution!

!

Save each change with the associated Set button.

Clicking the Set button saves the settings only in the current field. Changes in any other fields

 

are ignored.

 

 

 

Pre-programmed User Modes

 

Five (5) pre-programmed but configurable user modes, optimized with the best settings for a

 

variety of typical applications, make camera programming on-site easy and user-friendly. Users

 

select from the menu the mode that best defines the environment in which the camera is

 

installed:

 

Outdoor – general day-to-night changes with sun highlights and street lighting

 

Indoor – general day-to-night changes without sun highlights and street lighting

 

Lowlight – enhanced display of scene in low light

 

Motion – monitoring traffic or fast moving objects; motion artifacts are minimized

 

Vibrant – enhanced contrast color reproduction and sharpness

 

Users have the ability to customize these modes, if necessary, for the specific requirements of

 

the site.

12.3

Configuring Audio (Optional)

 

Enabling Audio Transmission

 

To transmit audio via the IP connection, follow these steps:

 

1.

Open the AUTODOME 7000 Series LIVEPAGE, then click the Settings tab.

 

2.

In the left pane, click Advanced, and then click Web Interface. The Web Interface menu

 

 

expands.

 

3.

Click LIVEPAGE Functions. The LIVEPAGE Functions page appears.

 

4.

Click the Transmit Audio radio button to enable for audio.

Activating Audio Reception

To configure audio via the Web browser, follow these steps:

1.Open the AUTODOME 7000 Series LIVEPAGE, then click the Settings tab.

2.In the left pane, click Advanced Mode, and then click Camera. The Camera menu expands.

3.Click Audio. The Audio page appears. The page displays the current video image in the small window next to the slide controls to help you verify the audio source and improve the Peak levels.

4.Select the protocol in the Audio field to activate audio over IP. (Change the option to ON.)

Notice!

The audio signal is sent in a separate data stream parallel to the video data, and so increases the network load. The audio data is encoded according to G.711 or L16 and requires an additional bandwidth of approximately 80 Kbit/s for each connection.

5.If you wish to configure the input and output gain of the audio signals, set the Line In and

Line Out fields to suit your specific requirements. Changes are effective immediately. The current level is displayed next to the slide control to help do this. Make sure that the display does not go beyond the green zone during modulation.

For more information, refer to Audio, page 108.

Bosch Security Systems

Operation Manual

2013.07 1.2.2 F.01U.283.679

Page 83
Image 83
Bosch Appliances 7000 manual Configuring Audio Optional, Pre-programmed User Modes, Enabling Audio Transmission