AutoDome 7000 Series (IP and HD)Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 31

7.4

Attach Pendant Arm to Power Supply Box

The bottom hinge pin of the Pendant Arm is provided with a Hinge Pin Stop to hold the hinge open while attaching the arm to the Power Supply Box.

1.Compress the bottom hinge pin by pushing the pin lever downward and rotating it behind the Hinge Pin Stop.

Figure 7.7: Pendant Arm to Power Box Hinge Alignment

2.Open the top hinge by pushing its pin lever up and holding it.

Notice!

Both Hinge Pins must be fully compressed to open (unlock) the hinges of the Pendant Arm and before proceeding to the next step.

3.While continuing to hold the top hinge pin open and align the top and bottom hinges of the Pendant Arm to their mating points on the Power Supply Box. See the illustration above.

4.Once you have aligned the hinges, release the top hinge pin to engage its mating hinge on the power box. Then release the bottom hinge pin from the Hinge Pin Stop to lock the Pendant Arm to the Power Supply Box.

Warning!

!Serious injury or death can occur if the hinge pins of the Pendant Arm are not fully engaged (locked) to the Power Supply Box. Exercise caution before releasing the Pendant Arm.

Bosch Security Systems

Operation Manual

2013.07 1.2.2 F.01U.283.679

Page 31
Image 31
Bosch Appliances 7000 manual Attach Pendant Arm to Power Supply Box, Pendant Arm to Power Box Hinge Alignment