Bosch Appliances 7000 manual Installing the VG4-A-9543 Pipe Mount

AutoDome 7000 Series (IP and HD) Installing the Roof Parapet and Pipe Mounts en 49

Figure 8.9: Attach Dome Cap

1

2

Thread Sealant or tape

Dome Cap

11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any gaps between the down pipe and the Dome Cap.

	12. Proceed to Wire the Pipe Interface Board, page 50.
	Notice!
	Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a
	threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye
	bolt and attach both ends to anchor spots on the roof.
8.5	Installing the VG4-A-9543 Pipe Mount
	This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
	the Roof Parapet mount, refer to Installing the VGA-ROOF-MOUNT, page 47 for instructions.

Notice!

Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length of 5 inches (12.7 cm).

You must use Teflon tape for thread-sealing compound. All screws shall be tightened securely.

Bosch Security Systems Operation Manual 2013.07 1.2.2 F.01U.283.679